News RSS

Attention! Before starting a work of the removing and installing of the bushings, choose the metal tubings (hub base and hub driver) for the removal and installation for each bushing. Hub base I.D. should be 1-2 mm. bigger than O.D. of the bushing’s flange (fig.3) not to interfere removing of the bushing. O.D. of the hub driver must be the same as O.D. of the inner metal sleeve.While removing, note the positions of big bushing and detents of the bushings. Mark the steering rack for the further correct installation.  Removal Place a steering rack upon the hub base into the press....

Read more

Attention! Before starting a work of the removing and installing of the bushings for the sway bar end links, take note of the shape and location of the thrust washers relatively to the bushings. Removal  Unscrew the nuts of sway bar end links. Remove the thrust washers. Dismount the outer bushings. Remove the end links from control arm and stabilizer. Dismount remaining inner bushings and thrust washers. Clean sway bar, thrust washers, housing areas of the end links and stabilizer from rust and dirt. Assess the quality of the parts. If necessary, replace the end links and thrust washers depending on...

Read more

Attention! Due to the structural diversity of the mounting of shock absorbers to the suspension and the body of the car, only the general principles of the bushings replacement are considered in this manual. Dismantling Unscrew the elements of the shock absorber mounting to the suspension and the body of the car. Remove the thrust washers. Remove the shock absorber from the car. Remove the worn out bushings by any suitable way. Remove the metal spacers, if any, applied to the shock absorber. Clean the thrust washers and spacers from rust and dirt. Rate the degree of wear and damage to...

Read more

Purpose of use.  Siberian Bushing spare parts are designed to replace the worn out rubber parts of the car chassis. Significant differences of Siberian Bushing spare parts. Design of some parts has been changed in comparison with the original ones. For example, original bushing has an outer metal shell, but that one of Siberian Bushing may be manufactured without it. For installation of some bushings the old metal shells are used. The old metal shells are carrying out the role of housing bores and are not removed from the arms. In cases of using the bushing without outer metal shell, the outer diameter of the...

Read more

Siberian Bushing USA offers a wide range of polyurethane bushings for the front and rear sway bar and lower/upper control arms. Compatible front sway bars:52124 887AD 68184 510AA 68184 511AA 68210 019AA 68213 310AA  Compatible rear sway bars:52124 885AF52124 885AG

Read more