News RSS

Thank you for this video to Dahlen Adventures: Youtube: https://www.youtube.com/watch?v=w4Zc7w-H0jo Intstagram: https://www.instagram.com/dahlenadventures/

Leer más

Dismantling Unbend the clamp of the leaf spring (fig.1). Push the leaf apart by any suitable way. Remove the worn out anti squeak pad from the bearing. Clean the bearings on the leaf spring from rust and dirt.   Installation Install new anti squeak pad on the bearing in the leaf spring. Fix the pad in the bearing. Bend the clamp of leaf spring. Removal and installation of the car suspension elements must be carried out according to the instructions of the car manufacturer, paying attention to the position of the car parts. Car suspension parts of Siberian Bushing are the...

Leer más

Removal and installation of the control arm bushing 4-06-2792 without outer metal shell. Attention! Control arm bushing 4-06-2792 unlike the original one does not have the outer metal shell. The installation of this bushing must be done into the outer shell of old bushing. Do not remove the old outer shell from the control arm. Remove only rubber in any convenient way. Removal Remove rubber from the control arm. Do not remove the outer shell of old bushing. Clean the housing area of the outer shell from dirt, rust, rubber remains. File and polish if any burr.  Installation  Choose a hub...

Leer más

Attention! Before starting a work of the removing and installing of the control arm bushings take note of the bushing’s placement. If the placement of the bushing is significant for the proper operation, mark the correct position for the bushing in control arm. If arm has a П-shaped profile, use the strut to avoid deformation while removing and installing the bushings. Removal  Choose the metal tubings (hub base and hub driver) for the removal and installation of the bushing. O.D. of the hub driver must be 0,5 mm. less than O.D. of the outer metal shell to avoid damage of the...

Leer más

Attention! Before starting a work of the removing and installation of the control arm bushing with stepped outer metal shell, take note of its placement. If the placement of the bushing is significant for the proper operation, mark the correct position of the bushing in the control arm. Determine the difference of the outer metal shell diameters and the direction of the bushing’s removal from the arm. Remove towards the increase of diameter. Install conversely towards the reduction of diameter. Removal  Choose the metal tubings (hub base and hub driver) for the removal and installation of bushing. O.D. of hub driver...

Leer más